Shipping & handling: 275. Then you get to route the window defroster wire through the soft top sleeve and stuff but that's way too hard to explain without pics. 2000-2005 Toyota MR2/MRS Spyder OEM Fiberglass Hardtop w/Hardware by ViS.Keep your eye on the 'Private Sales' section of the forum. The best fit and best quality hardtop is the Toyota OEM hardtop. A gutted one should weigh less than 40lbs. 2001 MR2 Spyder, 119whp/1850lbs, Hancook RS-3, D2 Coilovers, big wing. For such a funky looking car, the hardtop is surprisingly handsome.

The best part about the OEM hardtop is how it flows over the car. Replace the rear class with lexan and remove the interior pieces. Sharp angles on a rounded bubble dont look particularly good. Just buy a stock toyota hardtop and gut it. Run the seatbelt through the new plastic trim, install the reused plastic plugs into the trim and snap it into place. Each top with the hardware bought from toyota would cost close to 2K if made from carbon fiber.Mine came with 2 sets of bolts for the bottom hole, it didn't seem to matter which I used but I thought that was weird. TOYOTA MR2 MK3 Roadster Hardtop - Thermoformed Lexan Makrolon polycarbonate rear screen available in clear, bronze, grey and hardcoated polycarbonate from. Install the mounting posts using the supplied bolts.The HT should have come with 2 new trim parts with sections of them cut out to accommodate the hard top mounting posts. Remove the left and right plastic trim parts that the seat belt passes through (unbolt the seatbelt base).Replace them with the stainless latch parts I was wondering, I have 2001 MR-S and I recently purchased a hard top.Remove the rear tabs near the engine hinge that are body colored painted on the Left and Right side.

but if no one posts up I can send you a scan of the install info via PM on Sunday. It was a few years ago so I don't remember the actual instructions. Uses ModeloDrive poroprietary hardtop glass only (sold separately). Those things above aren't in any instructions but two things I noticed I messed up on the first hard top install. 1.8L 1794CC l4 GAS DOHC Naturally Aspirated. FL Intakes/Rear, FL Tailights, Supersprint Coilovers, VIS CF Hardtop, Hard Dog 1 Diag Rollbar, TRD Shifter, LR Header/JNZ Midpipe w/highflo cat/Team Moon Dual/Baffle, SSR 15圆.5 Wheels/Kumho XS 205. Did it come with all mounting hardware and modified plastic trim pieces?Ģ things on that - when you pull the seatbelts through the old trim pieces, be careful not to pop the retaining rivet off of the seatbelt when you pull it through the plastic trim that is being replaced.Īlso, when installing the new plastic trim using the plastic rivet(s) that holds it in place, do not push too hard otherwise you will 'crease' the trim and create a white mark from pushing to hard (like when you fold a credit card in half, you get that white stress line from bending plastic). A carbon fiber trunk (frunk) with vents takes the car a long ways as far as looks I think.

Toyota mr2 spyder carbon fiber hardtop